To remove the rear wheel, Honda designed a neat installation. You disconnect the rear brake rod, the rear brake torque
arm at the rear brake backing plate and swivel it out of the way, then you take the smaller nut off on the left side of the bike.
The smaller nut is the rear wheel axle bolt. The larger nut is the sleeve axle for the drive flange. The drive flange will stay along with
the rear drive chain. Then you pull the rear axle bolt, the right side rear wheel spacer will fall out, the right side axle adjuster will
come with the rear axle bolt. Now the rear wheel will slide to the right off the drive flange and you can remove the wheel from the
bike.
Bill
Portland OR
From: Jean Luc Picard <atari2600a@yahoo.com>
To: Honda-C70@yahoogroups.com
Sent: Saturday, September 3, 2011 12:41 AM
Subject: [Honda-C70] 2 rear axles?
So I removed the rear wheel as per Velodrome's instructions, & I'm a little baffled here. I was fiddling with the rear wheel (with someone sitting on the front seat to balance the bike on the block until I could push it forward) until I realized there was another rod connecting the flange to the wheel, yet I can't figure out where the hell it goes. I mean, I swear I pulled out the rear axle from the same place. My mind = blown
[Non-text portions of this message have been removed]
1970-73 C70 Honda Service Manual: http://tinyurl.com/6ebwtw
1970-73 C70 Troubleshooting Guide:
http://tinyurl.com/6ebwtw (scroll to sec.7.1 page 101.jpg)
1980-83 C70 Honda Service Manual: http://tinyurl.com/hu42c
1980-81 C70 Troubleshooting Guide:
http://tinyurl.com/hu42c (scroll to sec.18-1 page 170.jpg)
1982-83 C70 Troubleshooting Guide:
http://tinyurl.com/hu42c (scroll to sec. 20-28 page 205.jpg)
1980-81 C70 Maintenance Schedule: http://tinyurl.com/z4zn6
1982-83 C70 Maintenance Schedule: http://tinyurl.com/hw35c
More resources for C70 Passports and Cubs:
http://www.shlaes.com/Vehicles/Scooter.htm
http://www.velodrome.com/HondaC70/HondaC70.html
No comments:
Post a Comment